The famous Factory Pro "Supersport" jet kit -

No slide drilling

Use with the stock airbox, a stock or K&N stock replacement air filter and a stock or aftermarket exhaust.

This kit, when properly tuned, makes better lowend and midrange than the dynojet kit.

Config 30 / Stage 3 carb kit
No slide drilling

Use with INDIVIDUAL BMC or K&N filters and a stock or aftermarket exhaust.

This kit, when properly tuned, makes better lowend and midrange than the dynojet kit.
Does NOT include the pictured air filters.

Transmission Shift Improvement

Trans Detent Arm Kit

This Shift Detent Arm kit includes the Factory Pro Shift Spring and the Factory Pro Microbearing Detent arm

You ever miss second gear? Ouch! - poor bike! Miss it hard once and you bend the shift fork a little bit. Every time you miss that gear, the shift the fork bends a little bit more. Eventually, you will have to replace the 2nd gear fork, the gear that that the fork slides into and the gear that the sliding gear mates to! Bummer.
Prevent missed shifts and damage before it happens.
Make shifting MUCH quicker and virtually eliminate missed shifts. This is the same type of kit that Factory Pro, Honda, Kawasaki, Suzuki and Yamaha Racing has used. 

Tools

TL-float height gauge

$59.95 USD

The only way to accurately measure float heights. Works on nearly every carburetor. Float height measurement affects the fuel level in a carb - Fuel level controls the amount of fuel that the carb delivers at low rpm and cruise.

Looking for your idle mixture screws?  Here is where they are located: